arduino/debugSensor/sketch_debugSensor/sketch_debugSensor.ino

#include <Servo.h> 
#include <Metro.h>
Metro measureDistance = Metro(50);
Metro sweepServo = Metro(20);

unsigned long actualDistance = 0;

Servo myservo;  // create servo object to control a servo 
int pos = 60; 
int sweepFlag = 1;


int URPWM = 3; // PWM Output 0－25000US，Every 50US represent 1cm
int URTRIG= 10; // PWM trigger pin
uint8_t EnPwmCmd[4]={0x44,0x02,0xbb,0x01};    // distance measure command
 
void setup(){                                 // Serial initialization
  myservo.attach(9); 
  Serial.begin(9600);                         // Sets the baud rate to 9600
  SensorSetup();
}
 
void loop(){
 if(measureDistance.check() == 1){
      actualDistance = MeasureDistance();
//      Serial.println(actualDistance);
//      delay(100);
 }
 
 if(sweepServo.check() == 1){
      servoSweep();
 }
 
}

void SensorSetup(){ 
  pinMode(URTRIG,OUTPUT);                     // A low pull on pin COMP/TRIG
  digitalWrite(URTRIG,HIGH);                  // Set to HIGH 
  pinMode(URPWM, INPUT);                      // Sending Enable PWM mode command
  for(int i=0;i<4;i++){
      Serial.write(EnPwmCmd[i]);
   } 
}

int MeasureDistance(){        // a low pull on pin COMP/TRIG  triggering a sensor reading
    digitalWrite(URTRIG, LOW);
    digitalWrite(URTRIG, HIGH);               // reading Pin PWM will output pulses    
    unsigned long distance=pulseIn(URPWM,LOW);    
    if(distance==50000){              // the reading is invalid.
      Serial.print("Invalid");    
    }else{
      distance=distance/50;           // every 50us low level stands for 1cm
    }
    return distance;
}

void servoSweep(){
  if(sweepFlag ){  
     if(pos>=60 && pos<=120){                   
        pos=pos+1;                                  // in steps of 1 degree 
        myservo.write(pos);                         // tell servo to go to position in variable 'pos' 
    }
      if(pos>119)  sweepFlag = false;                       // assign the variable again
  }else {                                       
      if(pos>=60 && pos<=120){    
        pos=pos-1;
        myservo.write(pos);
      }
      if(pos<61)  sweepFlag = true;
   }
}